Table of Contents
Advertisement
OPERATION
1. Plug into the mains socket and
switch on,
2. Place the sanding disc on the
workpiece.
• Hold the sander firmly with both
hands.
3. Squeeze the trigger.
• Work gently across the
workpiece until smooth.
4. Release the trigger.
• Wait until the motor has stopped fully before putting the sander
down.
SPEED CONTROL
To control the speed, turn the knob
located on the trigger in the direction
marked, i.e. - = lower speed + =
higher speed.
LOCK ON FEATURE
For continuous sanding:
1. Squeeze the trigger and then
press the LOCK ON button.
• The sander will continue to run
even if the trigger is released.
2. To release the lock on feature, Squeeze the trigger again.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
10
Advertisement
Table of Contents
