Operation - Clarke CONTRACTOR CON320 Operation & Maintenance Instructions Manual

OPERATION

FITTING THE SANDING SHEET
1. With the sander disconnected from the power supply, select the sanding
sheet appropriate for the task and attach it to the base plate as follows.
Either plain sanding sheets or prepared sheets for hook and loop
attachment can be used.
PLAIN SANDING SHEETS
1. Lift the paper retaining clips to the
open position and insert one end
of the sanding sheet under the
retaining clip. Set the clip back in
the retaining position to hold the
sheet and lightly stretch it over the
baseplate, ensuring it is not folded
or wrinkled, then position it under
the other retaining clip. Lock the
second clip back into the
retaining position.
2. Check the sheet lays straight and
flat on the baseplate. If not,
release either clip and adjust the
sheet before resetting the clip.
HOOK AND LOOP SANDING SHEETS
1. Align the sanding sheet so that
the holes are aligned with those in
the base plate (this is necessary
for dust extraction), press the
sheet evenly onto the base plate
to attach it.
REPLACEMENT SHEETS
The following sanding sheets are available from your CLARKE dealer.
Grit
60
80
120
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Size (mm)
115 x 230 mm
115 x 230 mm
115 x 230 mm
Part No
6502072
6502073
6502074
8