Table of Contents
Advertisement
4. Attach hose to extension handle via twist & lock grommet and turn
clockwise to lock into place.
5. Attach dust bag to hose via twist & lock grommet and turn clockwise to
lock into place.
DUST COLLECTION
1. Ensure the sander is switched off.
2. Connect hose onto the dust
extract port on the underside of
the sander trigger handle.
3. Connect opposite end of hose
onto dust collection bag.
NOTE: The dust bag must be
emptied regularly:- do not wait until it is completely full.
The dust bag is emptied as follows.
1. Ensure the sander is switched off.
2. Gently remove the dust bag from
the hose.
3. Take the dust bag to the dustbin
and slide the clip off the bag,
empty the bag into the bin.
4. Reassemble the dust bag and clip
and fit back on to the hose.
OPERATION
1. Unfold handle and lock in place
with locking wheel.Careful to
avoid trapping fingers.
2. Attach extension handle, dust
hose and bag, as above.
3. Plug into the mains socket and
switch on,
4. Set speed of sander, see page 11
5. Place the sanding disc on the
workpiece.
• Hold the sander firmly with both hands.
6. Squeeze the trigger.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
10
Advertisement
Table of Contents
