Seam Pattern Input For Four-Hole Buttons - Pfaff 3307-3 Series Instruction Manual

11

Seam pattern input for four-hole buttons

.01.03
● Switch on the machine.
● Select the program number and button type, see Chapter 9.03.01 Selecting the button
type and program number.
● Call up the programming mode
● Select the desired parameter (P01, P02 etc.) with the left +/- keys.
● With the two corresponding +/- keys move to or select the desired positions (X and Y)
or values.
Parameter input four-hole button
● Operate the left +/- keys to take over the values entered and to call up the next or
previous parameter.
● Press the "programming" key to take over the values entered and to call up the sewing
mode.
No X
P 0 1 - 1 0
P01 First needle entry position
P02 Second needle entry position
P03 Third needle entry position
P04 Fourth needle entry position
P07 Total number of stitches (2-99)
P08 Intermediate trimming: I = off, II = on
P09 Stitch formation: 1 = normal, 2 = seam cycle, 3 = arrow, 4 = Z
P10 End knotting function: I = off, II = on
To achieve the best results, cutting should take place at the left needle entry
position. This is achieved through the number of stitches and the location of the
needle entry positions.
Y
2 0
Input
49