Table of Contents
Advertisement
11
Input
11
Seam pattern input on machines from subclass -3/..
.01
For each button type (two-hole, four-hole or three-hole button) 99 programs (seam patterns)
can be entered and stored. The seam pattern input is carried out by calling up or entering
certain seam parameters. The seam pattern input is described below for each button type.
11
Seam pattern input for two-hole and self-shank buttons
.01.01
●
Switch on the machine.
●
Select the program number and button type, see Chapter 9.03.01 Selecting the button
type and program number.
●
Call up the programming mode
●
Select the desired parameter (P01, P02 etc.) with the left +/- keys.
●
With the two corresponding +/- keys move to or select the desired positions (X and Y) or
values.
Parameter input two-hole button
●
Operate the left +/- keys to take over the values entered and to call up the next or
previous parameter.
●
Press the "programming" key to take over the values entered and to call up the sewing
mode.
No
X
P 0 1
- 1 0
P01
First needle entry position
P02
Second needle entry position
P07
Total number of stitches (1-99).
P10
End knotting function: I = off, II = on
To achieve the best results, cutting should take place at the left needle entry
position. This is achieved through the number of stitches and the location of the
needle entry positions.
Y
2 0
Input
47
Advertisement
Table of Contents
