Setting The Seam Pattern Size; Establishing The Value For Parameter "204 - Pfaff 3307-3 Series Instruction Manual

8

Setting the seam pattern size

.04
8

Establishing the value for parameter "204"

.04.01
1
Fig. 8 - 05
parameter "204"
Mounting and commissioning the machine
After the machine has been switched on for the fi rst time, fi rst of all the seam
pattern sizes set in the machine control unit must be checked and corrected if
necessary. The seam pattern size depends on the cut-out size of the bed plate
and is set with parameter "204". If these instructions are not observed there is
a risk of severe damage to the machine!
Value for
1
2
3
4
5
6
●
Measure the size of the cut-out in bed
plate 1.
●
With the use of the table below determi-
ne the value for parameter "204".
●
Set „parameter "204", which is the seam
pattern size, in accordance with Chapter
8.04.02 Changing parameter "204".
111-009
Bed plate
cut-out size
7 mm x 7 mm
8 mm x 8 mm
9 mm x 9 mm
10 mm x 10 mm
11 mm x 11 mm
10 mm x 14 mm
Seam pattern size
5 mm x 5 mm
6 mm x 6 mm
7 mm x 7 mm
8 mm x 8 mm
8 mm x 9 mm
8 mm x 12 mm
29