Table of Contents
Advertisement
Display
Description
Error 13
Stepping motor – targeted position outside sewing area
Time monitoring outputs
Error 14 - 3
Thread clamp
Error 14 - 6
Thread puller
Error 14 - 10
Material shift
Error 14 - 15
Programmable output 1
Error 14 - 16
Programmable output 2
Error 15
Input not incoming
Error 16
Non-permissible delay when sewing drive in operation
Error 17
Cutting without previous sewing
Error 18
Incorrect command in data set
Error 19
Incorrect program number
Error 20
Not assigned
Error 21
Power unit overloaded (24 V)
Error 22
Mains voltage
Error 23
Power unit 24 V too low
Error 24
No stepping motor motion prepared (NIS)
Error 25
Stepping motor still not started (NIS)
Error 26
Input blind stitching off (E5 – X5:5)
Error in SD-memory card reader
Error 27 - 1
No SD-memory card inserted
Error 27 - 2
Wrong card (does not match the 3307)
Error 27 - 3
Card not inserted correctly
Error 27 - 4
Card with write protection
Error 27 - 5
Data error on SD-memory card
Error 27 - 6
Formatting failed
Error 27 - 7
File does not match the 3307
Error 27 - 8
Incorrect fi le size
Error 27 - 9
Transfer error
Error 27 - 10
Data could not be deleted
Button feed
Error 28 - 1
Clamp not raised
Error 28 - 2
Loading position S1 not reached
Error 28 - 3
Stop position S2, or basic position S3 not reached
Error 28 - 4
Loading control (button not in position)
CAN-error
Error 29 - 1
Timeout
Error 29 - 2
Incorrect answer
Error 29 - 4
Data lost
Error 30
Error end knotting with penetration point number
Adjustment
129
Advertisement
Table of Contents
