Table of Contents
Advertisement
Controls
Every time the function keys 2 are operated, a key tone sounds as confi rmation of the
input. If the input required is invalid, e.g. because the max. permissible value for the
parameter input has been reached, a double tone is audible. An SD-card reader for data
transfer is integrated.
7
Screen displays
.06.01
●
●
7
Display symbols
.06.02
7
Function keys
.06.03
The functions keys described below are used essentially to switch machine functions on and
off. When the function is switched on, the diode in the key is illuminated.
If a corresponding value has to be fi xed for the activated function, this can be carried out
with the corresponding +/- keys 3.
By pressing and holding the corresponding +/- key, fi rstly the numerical value displayed abo-
ve it is altered slowly. If the +/- key is pressed longer, the numerical value changes more
quickly. The respective +/- keys shown opposite are described below.
Stop
●
●
Tacting forwards
●
●
22
In the sewing mode all relevant sewing data is displayed and can be changed directly, de-
pending on the status of the machine, see also Chapter 10 Sewing.
During the parameter input the selected parameter number with the corresponding value
is displayed, see Chapter 13.50 Parameter settings.
Speed
Piece counter
Program number
"Enter" function"
When operated during a sewing cycle, the machine is stopped.
When entering the code number this key corresponds to the fi gure 1.
This key is used to tact forwards through the entire sewing cycle step by step.
When entering the code number this key corresponds to the fi gure 2.
Danger of needle breakage!
Before tacting move the needle to its t.d.c. using the balance wheel.
Stem length
SD-memory-card
Machine memory
Advertisement
Table of Contents
