Panasonic MDF-DU702VH Service Manual page 70

⑥
Wire the gas sensor cable using the clampers on the marking
section on the bellow.
Remove CAP A attached to the base and wire the cable of the
gas sensor from the hole of the base to the back of the body.
⑦
Connect the harness UB_BATTRY_2 to the position marked with
the square in the right figure.
In the figure on the right, connect the red wire to the solid square
marker portion and the black wire to the dotted square marker
portion respectively.
Fix the four marking parts in the right figure with the truss head
screws M4x6.
⑧
Route UB_BATTRY_ 2 through the two clampers on the right figure.
⑨
Connect UB_BATTRY_1 and UB_BATTRY_2.
Fig.6-1
Fig.6-2
Fig.6-3
Fig.7-1
Fig.7-2
Fig.8-1
Fig.9-1
-67-
CAP A
circle：the hole for
screws of back-up kit
battery