Step 3: Presetting radio stations
(continued)
To stop scanning
Press TUNING MODE.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until "AUTO"
and "PRESET" disappear from the display in
step 2, then press TUNING + or – repeatedly to
tune in the station manually.
To set another station to the
exist preset number
Start over from step 1. After step 5, press . or
> on the remote to select the preset number on
which you want to store the station.
To erase a preset station
1 Press MENU/NO on the remote.
2 Press . or > repeatedly until "P.Erase ?"
appears.
Select "P.All Erase ?" when you want to erase
all the preset stations.
3 Press ENTER/YES on the remote.
4 Press . or > repeatedly to select the
preset number you want to erase.
5 Press ENTER/YES.
"Complete !!" appears.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
8
To change the AM tuning
interval (except for the European
model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the TAPE x
button, turn the system back on. When you change
the interval, all the AM preset stations are erased.
To reset the interval, repeat the same procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power
failure occurs.
• You can label the preset stations (see page 63).
• When an FM stereo program has static noise, press
STEREO/MONO until "MONO" scrolls in the
display. There will be no stereo effect, but the
reception will improve. Press the button again to
restore the stereo effect.