Table of Contents
Advertisement
Connecting Multiple Units
Connection Method
Up to four machines can be concurrently connected to a computer. When more than one machine is connected,
each machine needs to be identified on VPanel. An ID (A, B, C, and D) must be assigned to each machine to
configure the settings for each machine.
The explanations in this section assume that one machine is already connected and describe how to connect
one or more additional machines.
P. 40 "Installing the Software"
Procedure
Click
(VPanel icon) in the task tray on the desktop.
VPanel will be displayed. If you cannot find
[Start] screen (or the [Start] menu).
See P. 47 "STEP 3: Spindle Run-In (Long)".
Turn off the power of the connected machine, and then disconnect the USB cable from
the computer.
Switch on the power of the machine to be newly connected, and connect the USB cable
to the computer.
Configure the connections one machine at a time. Be sure to connect only the machine to be config-
ured. If you connect more than one machine with the same ID at the same time, the computer might
shut down or make driver installation impossible.
For the USB cable, use the included cable.
Do not use a USB hub. Connection may not be possible.
50
2. Installation and Setup
in the task tray, start the program from the Windows
Verify that OFF is displayed as the operation
status for all machines and that READY is
not displayed.
Select the machine that displays READY.
Click
The [Settings] screen will appear.
.
Advertisement
Table of Contents
