Step 2: Filling The Coolant Tank - Roland DWX-4W Setup Manual

Steps to Perform Following Installation

Continue on to "STEP 2: Filling the Coolant Tank."

STEP 2: Filling the Coolant Tank

CAUTION
CAUTION
Water to Use
Use soft or purified water. Using hard water may have a negative effect on the service life of the milling bur
and on the quality of the product.
Handling Additives
 You will need to prepare the designated additive separately. Contact your authorized Roland DG Corpora-
tion dealer to purchase additives.
 Store additives in a cool, dark place.
 Due to the characteristics of the internal components, the color may change and deposits of separated
components may form, but these do not indicate any problems with the use of the additives.
 If component deposits form, lightly shake the container to mix the components before use.
44
2. Installation and Setup
Do not overfill or tilt the coolant tank.
The fluid inlet on the coolant tank is open. Overfilling or tilting will cause fluid
to spill out.
When raising or lowering the coolant tank,
hold the positions indicated in the following figure.
Failing to do so may result in your fingers being pinched,
leading to injury.
Attach the waterproof plate on the inside
of the front cover.
Make sure that the protrusions on the front cover
are seated firmly in the 2 locations on the plate.