Printer Status; Beep On/Off; Rules For Routine Access Users - Hach AutoCAT 9000 Instruction Manual

3.3.7 Printer Status

3.3.8 Beep ON/OFF

3.3.9 Rules for Routine Access Users

50081_Operation.fm
See Printer Installation and Setup on page 153 for the printer installation procedure.
1. Select the printer status using the
Press the
CHECK MARK
2. Press the or
UP DOWN
the to validate and return to the Configuration Menu.
CHECK MARK
Note:If the printer option is enabled, a printer must be connected to the instrument. If no printer
is connected, an error message will be displayed and the instrument will try to detect a
printer for extended periods of time.
This selection toggles the ON/OFF status of the alarm beeper. If enabled, the AutoCAT
will emit an audible beep to alert the user to analysis completion, titrant expiration, etc.
1. Highlight Beep.
2. Press the
CHECK MARK
3. Press the or
UP DOWN
4. Press the
CHECK MARK
1. Access the Setup menu.
2. Select Access Routine Mode.
The Supervisor defines which operations can be ignored in routine mode. Configure
Demand and Alarm parameters for Titrant calibration by highlighting the desired
selection then pressing The configuration options are as follows:
Demand: Unlocked
The routine user can ignore the demand for titrant calibration and continue the
measurements.
Demand: Locked
The routine user must either calibrate the titrant or input a new titrant concentration
before continuing the measurements.
Alarm: Unlocked
The routine user can accept a titrant calibration even if the analysis result lies outside the
acceptance range specified by the method.
Alarm: Locked
The routine user must repeat the titrant calibration when the analysis result lies outside
the acceptance range specified by the method.
key to highlight Printer.
DOWN
to confirm the selection.
key. With the desired setting highlighted, press
to confirm the selection.
key
to validate and return to the Configuration Menu.
Basic Operation
Basic Operation
Page 29