TRENDnet User's Guide
Storage
Record Schedule
There are two kinds of recording for the cameras: manual recording and
scheduled recording. In this section, you can follow the instructions to
configure the scheduled recording. By default, the record files of scheduled
recording are stored in the local storage or in the network disk.
1. Check the checkbox of Enable to enable scheduled recording.
2. Click Advanced to set the camera record parameters.
© Copyright 2019 TRENDnet. All Rights Reserved.
Note: The record parameter configurations vary depending on the camera
model.
Pre‐record: The time you set to start recording before the scheduled
time or the event. For example, if an alarm triggers recording at 10:00,
and the pre‐record time is set as 5 seconds, the camera starts to
record at 9:59:55.
The Pre‐record time can be configured as No Pre‐record, 5s, 10s, 15s,
20s, 25s, 30s or not limited.
Post‐record: The time you set to stop recording after the scheduled
time or the event. For example, if an alarm triggered recording ends
at 11:00, and the post‐record time is set as 5 seconds, the camera
records until 11:00:05.
The Post‐record time can be configured as 5s, 10s, 30s, 1 min, 2 min,
5 min or 10 min.
Stream Type: Select the stream type for recording.
TV‐IP345PI
45