TRENDnet User's Guide
Server Port: The default server port number is 8000, and it can be
changed to any port No. ranges from 2000 to 65535.
Note:
When you use client software to visit the camera and you have changed
the server port number, you have to input the correct server port
number in login interface to access to the camera.
WebSocket Port: The default port number is 7681. It can be changed to
any port No. ranges from 1 to 65535.
WebSockets Port: The default server port number is 7682. It can be
changed to any port No. ranges from 1 to 65535.
2.
Click Save to save the settings.
Note: A reboot is required for the settings to take effect.
NAT
NAT interface allows you to configure the UPnP™ parameters.
Universal Plug and Play (UPnP™) is a networking architecture that provides
compatibility among networking equipment, software and other hardware
devices. The UPnP protocol allows devices to connect seamlessly and to
simplify the implementation of networks in the home and corporate
environments.
© Copyright 2019 TRENDnet. All Rights Reserved.
With the function enabled, you don't need to configure the port mapping for
each port, and the camera is connected to the Wide Area Network via the
router.
Steps:
1.
2.
3.
Enter the NAT settings interface. Configuration > Network > Basic
Settings > NAT.
Check the checkbox to enable the UPnP™ function.
Note:
Only when the UPnP™ function is enabled, ports of the camera are
active.
Choose a friendly name for the camera, or you can use the default
name.
TV‐IP345PI
28