Table of Contents
Advertisement
TRENDnet User's Guide
PPPoE
1.
Check the Enable PPPoE checkbox to enable this feature.
2.
Enter User Name, Password, and Confirm password for PPPoE access.
Note:
The User Name and Password should be assigned by your ISP.
For your privacy and to better protect your system against security risks,
we strongly recommend the use of strong passwords for all functions and
network devices. The password should be something of your own
choosing (using a minimum of 8 characters, including at least three of
the following categories: upper case letters, lower case letters, numbers
and special characters) in order to increase the security of your product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end‐user.
© Copyright 2019 TRENDnet. All Rights Reserved.
3.
Note: A reboot is required for the settings to take effect.
Port
You can change the service port numbers of TV‐IP345PI and enable/disable
RTSP or HTTPS services.
1.
Click Save to save and exit the interface.
Set the
ports of the camera.
HTTP Port: The default port number is 80, and it can be changed to any
port No. which is not occupied.
RTSP Port: The default port number is 554 and it can be changed to any
port No. ranges from 1 to 65535.
HTTPS Port: The default port number is 443, and it can be changed to
any port No. which is not occupied.
TV‐IP345PI
27
Advertisement
Table of Contents
