Table of Contents
Advertisement
TRENDnet User's Guide
4.
Select the port mapping mode. Manual and Auto are selectable.
Note:
If you select Auto, you should enable UPnP™ function on the router.
If you select Manual, you can customize the value of the external port
and complete port mapping settings on router manually.
5.
Click Save to save the settings.
Advanced Settings
SNMP
You can set the SNMP function to get camera status, parameters and alarm
related information, and manage the camera remotely when it is connected
to the network.
Before you start:
Before setting the SNMP, please download the SNMP software and
manage to receive the camera information via SNMP port. By setting
the Trap Address, the camera can send the alarm event and
exception messages to the surveillance center.
Note: The SNMP version you select should be the same as that of the
SNMP software. And you also need to use the different version
according to the security level you required. SNMP v1 provides no
© Copyright 2019 TRENDnet. All Rights Reserved.
3.
•
•
security and SNMP v2 requires password for access. And SNMP v3
provides encryption and if you use the third version, HTTPS protocol
must be enabled.
1.
Check the checkbox of Enable SNMPv1, Enable SNMP v2c, Enable
SNMPv3 to enable the feature correspondingly.
2.
Configure the SNMP settings.
Note: The settings of the SNMP software should be the same as the
settings you configure here.
Click Save to save and finish the settings.
Notes:
A reboot is required for the settings to take effect.
To lower the risk of information leakage, you are suggested to enable
SNMP v3 instead of SNMP v1 or v2.
TV‐IP345PI
29
Advertisement
Table of Contents
