Installing The System Board - Dell PowerEdge M630 Owner's Manual

Related links
Safety instructions
Before working inside your system

Installing the system board

After working inside your system
Removing a heat sink
Removing memory modules
Removing the cooling shroud
Removing a hard drive or SSD
Removing the hard drive or SSD backplane
Removing the hard drive or SSD cage
Removing the mezzanine card
Removing the Network Daughter Card
Replacing the internal USB key
Installing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver and the Hex nut driver-5 mm ready.
3. Unpack the new system board assembly.
CAUTION: Donotliftthesystemboardbyholdingamemorymodule, processor, orothercomponents.
CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
Steps
1.
Hold the system board by the connector end and orient it toward the front of the chassis.
2.
Align the USB connectors with the slots on the front wall of the chassis.
3.
Lower the system board and install the screws to secure the system board to the chassis.
105