Flash drive
The PowerEdge M630 system supports internal optional USB, internal optional SD card and optional vFlash card (with integrated
iDRAC8 Enterprise).
Ports and connectors specifications
USB ports
The PowerEdge M630 system supports:
•
USB 2.0-compliant ports on the front panel
•
internal USB 3.0-compliant port
The following table provides more information about the USB specifications:
Table 9. USB specifications
System
PowerEdge M630
Internal Dual SD Module
The PowerEdge M630 system supports two SD card slots anda USB interface dedicated for theembedded hypervisor. This card
offers the following features:
•
Dual card operation — maintains a mirrored configuration by using SD cards in both slots and provides redundancy.
•
Single card operation — single card operation is supported, but without redundancy.
Video specifications
The PowerEdge M630 system supports Matrox G200 VGA controller integrated withiDRAC and 2 GB shared withiDRAC
application memory.
Environmental specifications
NOTE: For additionalinformation about environmental measurements for specific system configurations, see Dell.com/
environmental_datasheets.
Table 10. Temperature specifications
Temperature
Storage
Continuous operation (for altitude less than 950 m or 3117 ft)
Fresh air
Maximum temperature gradient (operating and storage)
18
Frontpanel
One 4-pin, USB 2.0-compliant and one 4-
pin, USB 3.0-compliant
Specifications
–40°C to 65°C (–40°F to 149°F)
10°C to 35°C (50°F to 95°F) with no direct sunlight on the
equipment.
For information about fresh air, see Expanded Operating
Temperature section.
20°C/h (36°F/h)
Internal
•
Twointernal SD cards dedicated for
the hypervisor
•
One SD card dedicated for future
vFlash support