Figure 55. Removing the 1.8-inch (x4) SSD backplane
1.
hard drive or SSD backplane
3.
release latch (2)
5.
retention screw on the backplane cable connector (2)
Next steps
1.
Install the hard drive or SSD backplane.
2.
Install the hard drive or SSD.
3.
Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the hard drive or SSD cage
Installing the hard drive or SSD backplane
After working inside your system
Removing a hard drive or SSD
Installing the hard drive or SSD backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
NOTE: You must remove the hard drive or SSD backplane to replace a faulty hard drive or SSD backplane or service
other components inside the system.
1.
Follow the safety guidelines listed in safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
10
2.
hard drive or SSD backplane cable
4.
guide pin (3)
6.
connector on system board