Dell PowerEdge M630 Owner's Manual page 78

3. Followthe procedure listed in the Beforeworking inside yoursystem section.
4. Remove the mezzanine card.
Steps
1.
Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: Toprevent damage to the NDC, you must hold the card only by its edges.
2.
Lift the card from the system board.
Figure 31. Removing the NDC
1. slot on the NDC
3. NDC
5. connector
Next steps
1. Install the NDC.
2. Install the mezzanine card.
3. Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the mezzanine card
Installing the Network Daughter Card
Installing the mezzanine card
After working inside your system
78
2. screw (2)
4. standoff (2)
6. tab projections