Power Button Board Cable - HP Chromebook x360 11 Maintenance And Service Manual

1. Release the ZIF connector (1) to which the power button board cable is connected, and then disconnect
the power button board cable from the USB port board.
2. Release the ZIF connector (2) to which the USB Type-C port cable is connected, and then disconnect the
USB Type-C port cable from the USB port board.
3. Release the ZIF connector (3) to which the USB port cable is connected, and then disconnect the USB
port cable from the USB port board.
4. Remove the Phillips M2.0×3.5 screw (4) that secures the USB port board to the base enclosure.
5. Remove the USB Type-C bracket (5).
NOTE:
IMPORTANT:
6. Remove the USB port board (6).
Reverse this procedure to install the USB port board.

Power button board cable

Description
Power button board cable
Before removing the power button board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
The USB Type-C bracket is included in the Bracket Kit, spare part number 928089-001.
Be sure to replace the black tape atop the bracket.
Spare part number
929336-001
Component replacement procedures 31