Power Button Board Cable - HP Pavilion Gaming 15 Series Maintenance And Service Manual

Power button board cable

NOTE: The power button board cable is available using spare part number L56908-001.
Before removing the power button board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. WLAN module (see
c. Solid-state drive (see
d. Hinge trunks(see
e. Fan brackets (see
f. Fan/heat sink assembly (see
g. System board (see
h. Power button board (see
Remove the power button board cable:
1. Turn the power button board upside down with the front toward you.
2. Release the ZIF connector (1) to which power button board cable is connected, and then disconnect
the power button board cable from the power button board.
3. Remove the power button board cable (2).
Reverse this procedure to install the power button board cable.
64 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 36)
WLAN module on page
Solid-state drive on page
Hinge trunks on page
Fan brackets on page
Fan/heat sink assembly on page
System board on page
Power button board on page
32), and then remove the following components:
39)
41)
44)
45)
46)
56)
62)