Power Button Board Cable - HP Pavilion x360 Maintenance And Service Manual

Power button board cable

NOTE: The power button board spare part kit does not include the power button board cable. The power
button board cable is available using spare part number 924411-001.
Before removing the audio jack board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the keyboard/top cover (see
5. Remove the battery (see
Remove the power button board cable:
1. Release the ZIF connector (1) to which power button board cable is connected, and then disconnect
the power button board cable from the system board.
2. Release the ZIF connector (2) to which power button board cable is connected, and then disconnect
the power button board cable from the power button board.
3. Detach the button board cable (3) from the display hinge. (The button board cable is attached to the display
hinge with double-sided adhesive.)
4. Remove the power button board cable.
Reverse this procedure to install the power button board cable.
40 Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
Battery on page 34).
27).