Fitting The Throttle Sensor - APRILIA RSV Mille 1000 1999 Technical Training Course

Aprilia Consumer Service Spa
Technical Service and Training
Release 4 july 99

Fitting the throttle sensor:

(Please see section 9 for CO regulation)
With the engine off, turn the ignition key to ON.
When positioned in the throttle body, enable the control unit diagnostics function.
If there are no errors (i.e. sensors all OK) one of three possible numbers will appear:
+1: initial angle reading too high
0: throttle position OK
-1: initial angle reading too low
Turn the sensor until the 0 appears.
Fix the sensor in position.
Next, proceed with making the fine air setting on the injectors to balance the idling rate
This material is didactic and
may be changed following the technical
development of the product