Fitting The Seat Plate; Adjusting The Backrest Cover - Invacare Aquatec Ocean E-VIP User Manual

Assembly and installation
1. Undo the screw with hand knob A.
2. Select the length of chest belt E.
3. Use the screw with the hand knob to screw the chest belt onto the
mounting bracket.

4.5 Fitting the seat plate

Attachment:
CAUTION Danger of pinching fingers
▸ Do not insert fingers between the seat surface and seat
frame when pressing down the seat plate.
1. Place seat plate A on seat frame B with the cut out facing to the
front.
2. Slide the seat plate back as far as it will go.
3. Using the flat of your hand, press down on the sides and then the
front and back of the seat plate until the seat plate clicks into the
seat frame.
Removal:
1. Pull up the seat plate on both sides.
Shower and Toilet Commode Ocean E-VIP

4.6 Adjusting the backrest cover

IMPORTANT
▸ To attach accessories or the chest belt, open the second
belt buckle from above and pass the backrest cover on the
inside of the backrest frame C at this point.
▸ At least three belts must always go around the outside of
the backrest frame and their buckles must be closed.
The tension of the backrest can be adjusted as desired.
Tightening
1. Tighten belts A on the backrest cover.
Loosening
1. Open belt buckles B by squeezing the retaining lugs together
(arrows).
2. Push the belts back a little through the buckle.
3. Close the buckles.
4. Tighten the belts slightly.
9