Identification Label; Assembly And Installation; Safety Information; Assembling The Seat Frame - Invacare Aquatec Ocean E-VIP User Manual

Shower and Toilet Commode Ocean E-VIP

3.2 Identification label

The identification label contains important information:
K
G
L
J
B E
A Conformity mark
B Duty cycle (max. 10%, max. 2 min/18 min)
C Note (disposal)
D Type of protection
E Serial device number
F Note (observe accompanying documents)
G Production timeframe
H Load capacity
I Nominal voltage/rated power
J Type B applied part
K Device designation
L Note (only suitable for use on flat surfaces)
The identification label is applied to the rear left side tube.
i
6
F
A
C
H
D
I
4

Assembly and installation

4.1 Safety information

IMPORTANT
▸ Check the parts for transport damage before
commissioning and contact the dealer if required.
▸ Ensure during assembly that the parts are positioned
correctly with respect to one another.
This section explains how to assemble the product.
The product is dismantled in the reverse order.

4.2 Assembling the seat frame

WARNING
Risk of bolts slipping out.
▸ Make sure that the safety clips engage and
are correctly fitted (see diagram below).
1. Secure all the wheels with the red foot levers. To do this, press
down on the red foot lever on the wheels.
2. Remove the drive for the seat tilt A from the chassis.
To do this, cut through the cable tie.
3. Push the fork B at the lower end of the drive A onto lip D at the
back edge of the chassis and align the holes.
4. Insert bolt E (35 mm) into the holes from the outside and push it
in fully.
Assembly and installation