Setting The Armrest Height - Invacare Aquatec Ocean E-VIP User Manual

Shower and Toilet Commode Ocean E-VIP
WARNING Risk of injury due to damaged backrest
buckles!
Check for secure fastening of the backrest buckles each time
the product is maintained or reconditioned.
▸ Check all buckle clips for secure fastening by closing the
buckles and pulling on both ends.
▸ Replace the backrest/backrest buckles if a buckle opens
under the applied force.

4.7 Setting the armrest height

IMPORTANT
▸ Adjust the height of the armrests to suit the user.
▸ Adjust the height of the armrests equally on both sides.
▸ The height of the right and left armrest is adjusted in the
same way.
10
B
C
D
A
B
1. Open the belt buckle on the backrest cover which is passed on the
inside of the backrest frame.
2. Open the belt buckle of belt C on the backrest cover, which is
above the armrest.
3. Pass this belt on the inside of the backrest frame and close it again.
The nuts are inserted loosely into the retaining clamp and may
i
drop out.
4. Undo screws B of armrest bracket A using the Allen key supplied.
5. Remove retaining clamp D with the nuts from the inside of the
backrest frame.
6. Remove armrest bracket A together with the armrest and move it
upwards.
The smaller hole is provided to secure the retaining clamp.
i
7. Insert the screws into the armrest bracket and guide them through
the holes in the backrest frame.
8. If necessary reinsert the nuts into the retaining clamp.
9. Place the retaining clamp on the backrest frame in such a way that
the fixing on the retaining clamp engages in the smaller hole.
10. Turn the screws in the nuts and tighten them.
11. Pass the open belt of the backrest cover on the outside of the
backrest frame, close and tighten all the belts.
IMPORTANT
The armrests are adjusted to the lower position in the same
way.
▸ When adjusting to the lower position, the belt beneath
the armrest must be opened and passed on the inside the
backrest frame.
Assembly and installation