Fitting The Headrest - Invacare Aquatec Ocean E-VIP User Manual

Assembly and installation
5. Attach a safety clip C on the inside.
6. Insert cable B of drive D as far as possible into chassis A.
7. Use cable tie C provided to secure the cable of the drive in this
position.
IMPORTANT
The armrests face forward when folded down.
8. Insert both sides of seat frame F into receivers H on chassis J.
9. Insert the two 35 mm bolts G into receivers H from the outside,
push in fully and attach safety clips I on the inside.
10. Tilt the seat frame until the holes in bracket E on the seat frame
and in fork A on seat tilt drive D are aligned.
Shower and Toilet Commode Ocean E-VIP
11. Insert the 23 mm bolt B into the holes from the outside and attach
safety clip C on the inside.

4.3 Fitting the headrest

IMPORTANT
Retaining bar C can be fitted with the curve to the front or
back, depending on the user's requirements.
The headrest cushion J can be removed and replaced with
other cushion shapes (optional).
▸ To remove the cushion, undo mounting screws I.
1. Twist the screw with hand knob F a little way into brace G.
2. Attach the brace with the screw to the handle of backrest E from
the back in such a way that the screw enters the hole in the handle
of the backrest.
3. Insert plate D into the brace from the front in such a way that the
two lips of the plate face upwards and downwards and the curved
side of the plate meets the handle of the backrest.
IMPORTANT
When inserting the support, the curve of the plate must be
fully flush with the backrest handle.
4. Insert retaining bar C into the recesses of the brace from above.
5. Tighten the screw with hand knob F until the retaining bar is
secure.
6. Insert cushion J together with cushion support B into bracket H
on the retaining bar.
7. Tighten the upper screw with hand knob A until the cushion sup-
port is secure.
7