Table of Contents
Advertisement
4.
Transport and storage
Observe the instructions in section 3, "Safety instructions"!
4.1
Scope of supply
The products supplied are listed in the dispatch papers. Check on receipt to ensure that all the products
listed have actually been delivered. Parts damaged and/or missing parts must be reported to Siemens in
writing immediately.
WARNING
Serious injury through defective product
If there is any visible damage, the gear unit must not be put into operation.
4.2
Transport
Note
The weight of the product is specified on the rating plate.
DANGER
Danger of life
Danger to life from loads falling through incorrect slinging
Do not stay under suspended loads.
When attaching, lifting, lowering and shifting loads, observe the following:
– Note the load limits.
– Correct fastening of the slinging equipment.
– Any centre of gravity which is off the load centre.
– Even load distribution when using loadcarrying means with several load hooks.
– Low displacement speed.
– The load must not be swung and/or attached to objects or building parts.
– Lifting hooks must not be loaded by the tip.
– Always place the items on an even, slipfree and stable surface.
WARNING
Danger of squeezing
Risk of being squeezed by a transported component, when the used lifting gear and loadcarrying means
are not suitable and the component gets loose.
The unit may be attached only at the marked slinging points. Use only lifting and loadcarrying equipment
of sufficient loadbearing capacity.
When lifting items, observe the notes regarding load distribution on the packing.
The product must be handled slowly and carefully, when lifted, to avoid personal injury and damage to
the gear unit.
If, for example, the free shaft ends are knocked, this may cause damage in the gear unit.
The gear unit is delivered in the fully assembled condition. Additional items may be delivered separately
packaged, if applicable.
BA 5080 en 06/2014
15 / 72
Advertisement
Table of Contents
