Preset Vhf Weather Broadcast Receiver Memory Channels - Yaesu FT3DR Operating Manual

Preset VHF Weather Broadcast Receiver Memory Channels

The frequencies (10 channels) used for the VHF Weather Broadcast Stations are regis-
tered in dedicated preset receiver memory channels.
1. Press the [A/B] key to set the A-band as the operating band.
2. Touch [F MW], and then touch [P.RCVR].
If [P.RCVR] is not displayed, touch [BACK ←] to display [P.RCVR] and touch it.
3. Press the [BAND] key to select [WX CH].
4. Rotate the DIAL knob to select the desired channel.
• For the available Weather Broadcast channels, see the following table.
• To stop receiving the WX Channel Frequency, press the [BACK] key or touch
[F MW] followed by [P.RCVR].
Memory channel No.
1
2
3
4
5
In the event of extreme weather disturbances, such as storms and hurricanes, the
NOAA (National Oceanic and Atmospheric Administration) sends a weather alert accom-
panied by a 1050 Hz tone and subsequent weather report on one of the NOAA weather
channels. You may enable the Weather Alert tone via Set Mode option [SIGNALING] →
[14 WX ALERT], if desired (See page 74).
40
WX Channel Frequency List
Frequency (MHz)
162.550
162.400
162.475
162.425
162.450
Memory channel No.
6
7
8
9
10
Frequency (MHz)
162.500
162.525
161.650
161.775
163.275