Clearing Memories; Restore Erased Memory; Recalling The Home Channels; Changing The Home Channel Frequency - Yaesu FT3DR Operating Manual

Clearing Memories

1. Touch and hold [F MW].
2. Rotate the DIAL knob to select the memory channel
from which the data is to be cleared.
3 . Tou c h [ ], then touch [M.DEL].
Confirmation screen "DELETE?" is displayed.
4. Touch [OK] twice to clear the memory channel.
• Data on memory channel One, and the Home channel may not be cleared.
• The erased memory channel can be recovered by the following procedure.

Restore erased memory

1. Press the [V/M] key to enter the memory mode.
2. Touch and hold [F MW].
3. Rotate the DIAL knob to select the channel to be
restored.
4. Touch [ ].
5. Touch [M.REV].
Confirmation screen "DELETE?" is displayed.
6. Touch [OK] to restore the memory channel.

Recalling the Home Channels

1. Touch [F MW], and then touch [HOME].
If [HOME] is not displayed, touch [BACK ←] to display
[HOME] and then touch it.
z "HOM" and the home channel frequency of the cur-
rently selected band appears on the LCD.
2. Press the [V/M] key, or touch [F MW] and then touch
[HOME] to return to the previous frequency.
• While recalling the home channel, rotate the DIAL knob to transfer the home channel
frequency to the operating band VFO.
• The home channel frequency can be set not to be transferred in the Set Mode [CONFIG]
→ [8 HOME VFO] (page 79).

Changing the Home Channel Frequency

1. Set the frequency and the operating mode to be stored as a home channel.
2. Touch and hold [F MW].
3. Touch [ ].
4. Touch [H.WRITE].
Confirmation screen "OVERWRITE?" is displayed.
5. Touch [OK] twice.
The beep sounds and the home channel frequency is changed.
34