Table of Contents
Advertisement
Invacare® Ultra Low Maxx by Motion Concepts
Adjust armrest height
Tools:
•
13 mm open-ended wrench
1. Loosen screws A.
2. Adjust armrest B to desired height.
3. Tighten screws.
Adjust armrest angle
Tools:
•
13 mm open-ended wrench
1. Loosen lock nut A.
2. Adjust armrest angle by adjusting thread rod with
thumb nut B:
•
To lift armrest, screw in thread rod.
•
To lower armrest, screw out thread rod.
3. Tighten lock nut.
56
9.4 Replacing the Cantilever Seat
Mount Armrest
For tightening torques on hardware, refer to
Tightening Torques.
1. Flip up arm to access the mounting screws.
2. Remove the two mounting screws A and washers B
that secure the arm post pivot mount assembly C to
the clamping bar D inside the channel of the side
rail E.
3. Remove the arm post pivot mount assembly from
side rail.
4. Remove clamping bar from inside of channel of side
rail.
5. Discard existing armrest and attaching hardware.
6. Slide new clamping bar into channel of side rail.
7. Secure new arm post pivot assembly to clamping bar
with two mounting screws and washers.
8. Install new upper armrest assembly F into arm post
pivot assembly and secure in place with locking lever
G.
9.5 Ultra Rail Mounted Flip Back
Cantilever Maxx Armrest
Adjusting Position
F
E
C
B
A
G
Fig. 9-3
1586649-F
D
Advertisement
Table of Contents
