Installing/Adjusting Trough Arm Pad; Replacing Hand Pad; Adjusting Two Post Recline Armrest - Invacare Motion Concepts Ultra Low Maxx Service Manual Supplement

Invacare® Ultra Low Maxx by Motion Concepts
Fig. 9-12 Centre
Fig. 9-11 Outside
mount
Depth Adjustment
You can adjust the arm pad depth by 1.75 inch (45 mm).
Fig. 9-14
1. Loosen mounting screws A.
2. Adjust arm pad to desired position.
3. Re-tighten screws.
9.11 Installing/Adjusting Trough Arm
Pad
Fig. 9-15
For tightening torques on hardware, refer to
Tightening Torques.
Installing Arm Pad
1. Slide nut plates A into one of channels B in trough
arm pad C.
2. Position trough arm pad onto armrest tube D in
desired location.
3. Insert screws E through armrest tube and into nut
plates to secure in place.
60
Fig. 9-13 Inside
mount mount
Adjusting Width
1. Remove screws E that secure trough arm pad C to
armrest tube D.
2. Remove nut plates A from channel B of trough arm
pad.
3. Re-insert two nut plates into desired channel of trough
arm pad.
4. Secure trough arm pad to armrest with screws.
Adjusting Depth
1. Loosen screws.
2. Adjust trough arm pad to desired position.
3. Re-tighten screws.
Adjust joystick to desired position.

9.12 Replacing Hand Pad

Fig. 9-16
For tightening torques on hardware, refer to
Tightening Torques.
1. Remove eight screws A that secure hand pad B to
trough arm pad C.
2. Slide clamping bars D out of trough arm pad.
3. Discard existing hand pad, clamping bars and attaching
hardware.
4. Slide new clamping bars into trough arm pad.
5. Secure clamping bars to trough arm pad with four
screws.
6. Slide hand pad onto clamping bars.
7. Secure hand pad to clamping bars with four screws.

9.13 Adjusting two post recline armrest

The two post recline armrest has an adjustable pivot arm
to allow height adjustments in 13 mm increments.
Tools:
• 5 mm Allen key
• 13 mm wrench
1586649-F