Adjusting The Length Of The Legrest; Adjusting The Depth Of The Calf Pad; Adjusting The Height Of The Calf Pad; Unlocking And Swivelling The Calf Pad Backward - Invacare Motion Concepts Ultra Low Maxx Service Manual Supplement

10.5.4 Adjusting the length of the legrest

CAUTION!
Risk of injury due to incorrect adjustment of
the footrests and legrests
– Before and during every journey it is
imperative to ensure that the legrests contact
neither the castor wheels nor the ground.
• 5 mm Allen key
1. Use the spanner to loosen the screw (1).
2. Adjust to the desired length.
3. Re-tighten the screw.

10.5.5 Adjusting the depth of the calf pad

The depth of the calf pad can be adjusted via the holding
plate. The holding plate hole combinations allow 5
different depth settings.
• 10 mm wrench
1. Use the wrench to loosen the nut (1) and remove.
2. Adjust to the desired depth. Observe that the round
holes are intended for the calf pad retaining screw
and the oblong holes for the aglet without thread.
3. Screw the nut back on and tighten.

10.5.6 Adjusting the height of the calf pad

• 4 mm Allen key
1586649-F
1. Use the Allen key to loosen the screws (1).
2. Adjust to the desired position.
3. Re-tighten the screws.
10.5.7 Unlocking and swivelling the calf pad
backward when alighting
1.
Press the calf pad straight down.
2.
Unlock the legrest and swivel outward.
The calf pad swivels backward on its own.
3.
Lift leg over the heel strap and place on the ground.
10.5.8 Adjusting the angle–adjustable foot
plate
• 5 mm Allen key
Legrests
75