Adjusting Swing-Away Display Holder; Quad Link; Installing Remote Onto Quad Link - Invacare Motion Concepts Ultra Low Maxx Service Manual Supplement

Invacare® Ultra Low Maxx by Motion Concepts
Insert screws E, washers B and nuts C into adapter
A and swing–away remote holder D and tighten.
2.
Insert swing–away remote holder D into armrest
bracket and tighten screw F.
12.2 Adjusting Swing-Away Display
Holder
Adjusting Holder Height
• 3 mm Allen key
1. Loosen screws A.
2. Position holder to desired height.
3. Tighten screws.
Adjusting Holder Orientation
The holder can be turned through 360 degrees.
• 3 mm Allen key
86
Fig. 12-6
1. Loosen screws A.
2. Adjust holder orientation.
3. Tighten screws.
Adjusting Display Orientation
The display can be turned through 360 degrees.
• 18 mm wrench
1. Loosen clamping bush A.
2. Adjust display orientation.
3. Tighten clamping bush.

12.3 Quad Link

12.3.1 Installing Remote onto Quad Link (until
February 2017)
By default, the remote is mounted centered regardless of
which side of the wheelchair the remote is mounted on.
The position of the remote A on the adjustable remote
tray B can nevertheless be adapted as shown below:
Fig. 12-7
Right Mount Front View
(For Right Hand Use)
Left Mount Front View (For
Left Hand Use)
1586649-F