Table of Contents
Advertisement
Section 4 Engineering
2.
Install device specific drivers. (normally downloadable from the device
vendor) The drivers are installed using Windows new hardware detected
wizard.
3.
Open the Computer Management tool by right-click on My Computer in the
Start menu and select manage. Click Device Manager and expand Ports.
4.
Check which port your new device has been connected to. (Normally Com3)
5.
Configure the SMS device used to send the messages. This is configured in the
aspect:
[Aspect System Structure]Aspect System Structure/Messenger/SMS
Device/SMS Device:SMS Device
6.
To configure please click the Ports tab and click Add.
7.
Select the Port that you got above (normally port 3), click Next.
8.
Enter the phone number for the phone that you are using including country
code.
9.
Enter the Initialization string for the Phone you are using. (look in help for
initialization strings)
For newer models of SonyEricsson phones use the Initialization command
string:
"AT+CBST=0,0,1;+CHSN=4,2,0,12" (omit the " characters)
10. Configure the User that is supposed to receive the messages. This is done in the
"Message Subscriber" and "Message Schedule" aspects on the user objects in
the user structure.
Note, that the phone number entered in the Message Subscriber aspect should be
without country code. e.g. 0701234567
11. Define which alarms and events that should be sent as SMS messages by
adding and configure an "Alarm and Event list" aspect that defines which
messages that should be sent out.
12. To direct the messages in the list to be sent as SMS messages you need to
configure a "Message Handler" and an "Alarm and Event Message Source"
aspect on the same object as where the alarm list is located. (No shortcuts
available.)
3BSE040587R4401
Messaging Configuration
83
Hide quick links:
Advertisement
Table of Contents
