Autonomous Redundancy Setup - ABB IndustrialIT Compact HMI 800 Getting Started

Section 7 Administration
Figure 78. Select Type of Configuration - HMI-Server88
6. Select Start and press Next and then Finish.
7. Wait until the system has started. (The dialog in step 2 shows up).

Autonomous Redundancy Setup

Compact HMI 800 supports an autonomous redundancy scheme. This means that
two Compact HMI systems are running in parallel accessing the same controllers.
One of the systems are considered to be the main system and the second is the
backup system.
All configuration changes should be done in the main system and then transferred to
the backup system by using the system backup function.
The setup of an autonomous redundancy configuration is done by the following
main steps:
1. Make a system backup of the configuration in the main system.
3BSE040587R4401
Autonomous Redundancy Setup
127