Change The Windows Computer Name In The Server Node - ABB IndustrialIT Compact HMI 800 Getting Started

Change the Windows Computer Name in the Server Node

2. Change the windows computer names and IP addresses in the backup system,
including restore of the backup created in Step 1.
Step 1 and Step 2 are described in more detail in the chapters
Configuration Data
Change the Windows Computer Name in the Server Node
To change the Windows Computer Name of the Compact HMI 800 Server node
please go through the following steps:
1. If the node name is change directly after delivery the steps 2 and 3 can be
omitted. In this case proceed to step 4.
2. Make a Ghost backup of the node, using the Norton Ghost software supplied in
the original delivery of the Compact HMI 800.
3. Make a system backup (will be restored in a later step) as described in
and Restore of Configuration Data
4. Log in as SysAdmin.
5. Stop the system as described in
128
and Change the Windows Computer Name in the Server
on page 117.
To Stop and Start the System
Section 7 Administration
Backup and Restore of
Node.
Backup
on page 123.
3BSE040587R4401