Speaker Volume; Ringer Volume - Avaya IP Office D100 Manual

Speaker volume

Adjust the handset speaker volume using the Up and Down keys on the side of the handset. The
handset and the headset have separate volume level settings. When you press the Up or Down
keys during a call, the handset display shows the current volume level.
If you receive a message from IP Office while you are setting the volume, it appears after displaying
the volume level.

Ringer volume

Use the following procedure to change only the ringer volume. If you want to change the ringer
volume while a call is incoming, you can use the same procedure but the handset does not display
the setting. The handset continues to display the incoming call information.
To change the ring tone, see
Procedure
1. In the Idle state, press the Up or Down keys on the side of the handset to enter the Ringer
Volume Setting mode.
2. Continue to press Up or Down to increase or decrease the ringer volume accordingly.
The following settings are available:
• Low: The handset emits a quiet ring tone.
• Middle: The handset emits a medium level ring tone.
• High: The handset emits a loud ring tone.
• Vibrate: The handset vibrates rather than emitting a ring tone, unless the handset is in the
charger, in which case the ring tone rings Low.
• Off: The ringer is muted.
3. When you are satisfied, allow the handset to display the volume setting without pressing any
keys. Pressing either the On-Hook key or the Off-Hook/Handsfree key cancels the Ringer
Volume Setting mode.
January 2016
Changing the ring tone
Using IP Office D100 SIP Wireless Terminal
on page 15.
Speaker volume
31