System Reboot - ZyXEL Communications LTE3316-M604 User Manual

The following table describes the labels in this screen.
Table 70 Maintenance > Backup/Restore
LABEL
Backup Configuration
Backup
Restore Configuration
File Path
Choose File
Upload
Reset to Defaults
Reset
Note: If you uploaded the default configuration file you may need to change the IP address
of your computer to be in the same subnet as that of the default Zyxel Device IP
address (192.168.1.1).

25.8 System Reboot

System restart allows you to reboot the Zyxel Device without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 111 Maintenance > Restart
Click Restart to have the Zyxel Device reboot. This does not affect the Zyxel Device's configuration.
Chapter 25 Maintenance
DESCRIPTION
Click Backup to save the Zyxel Device's current configuration to your computer.
Type in the location of the file you want to upload in this field or click Browse... to find it.
Click Browse... to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Click Upload to begin the upload process.
Note: Do not turn off the Zyxel Device while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the Zyxel Device again. The Zyxel Device automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information and
returns the Zyxel Device to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your Zyxel
Device. Refer to the chapter about introducing the Web Configurator for more information on
the RESET button.
LTE3316 Series User's Guide
169