ZyXEL Communications LTE3316-M604 User Manual page 25

Table 4 Navigation Panel (continued)
MENU SUB-MENU
DHCP Server General
Advanced
Client List
NAT General
Port Forwarding
Port Trigger
ALG
DMZ
Dynamic DNS Dynamic DNS
Routing Static Route
Dynamic Routing
Interface Group Interface Group
Security
Firewall General
Services
Content Filter Content Filter
IPv6 Firewall Services
Application
VPN L2TP Server
L2TP Client
GRE
VPN Passthrough
SMS SMS
Voice Call General
Call Conf.
Management
MGMT Interface Local MGMT
Remote MGMT
Bandwidth MGMT General
UPnP UPnP
TR069 TR069
Maintenance
Chapter 2 Web Configurator
DESCRIPTION
Use this screen to enable the Zyxel Device's DHCP server.
Use this screen to assign IP addresses to specific individual computers
based on their MAC addresses and to have DNS servers assigned by the
DHCP server.
Use this screen to view information related to your DHCP status.
Use this screen to enable NAT.
Use this screen to configure servers behind the Zyxel Device and forward
incoming service requests to the server(s) on your local network.
Use this screen to change your Zyxel Device's port triggering settings.
Use this screen to enable or disable SIP (VoIP) ALG (Application Layer
Gateway) in the Zyxel Device.
Use this screen to set the IP address of your network DMZ (if you have
one) for the Zyxel Device.
Use this screen to set up dynamic DNS.
Use this screen to configure IP static routes.
Use this screen to enable and configure RIP on the Zyxel Device.
Use this screen to create a new interface group.
Use this screen to activate/deactivate the firewall.
This screen shows a summary of the firewall rules, and allows you to edit/
add a firewall rule.
Use this screen to restrict web features and designate a trusted
computer. You can also block certain web sites containing certain
keywords in the URL.
Use this screen to configure IPv6 firewall rules.
Use this screen to configure the Zyxel Device L2TP server settings.
Use this screen to configure the L2TP VPN client settings.
Use this screen to configure the GRE VPN client mode tunnel settings.
Use this screen to allow VPN traffic to pass through the Zyxel Device.
Use this screen to view the SIM card's SMS inbox and send short
messages.
Use this screen to enable voice service in the Zyxel Device.
Use this screen to configure enable call forwarding and configure call
forwarding rules in the Zyxel Device.
Use this screen to specify from which zones you can access the Zyxel
Device using HTTP, HTTPS, SSH or Telnet.
Use this screen to enable specific traffic directions for network services.
Use this screen to enable bandwidth management, set the upstream
bandwidth and edit a bandwidth management rule.
Use this screen to enable UPnP on the Zyxel Device.
Use this screen to configure your Zyxel Device to be managed by an
ACS.
LTE3316 Series User's Guide
25