Dynamic Routing - ZyXEL Communications LTE3316-M604 User Manual

The following table describes the labels in this screen.
Table 41 Network > Routing > Static Route: Add/Edit
LABEL
Static Route
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Back
Cancel
Apply

13.3 Dynamic Routing

Use this screen to enable and configure RIP on the Zyxel Device. Click Network > Routing > Dynamic
Routing to open the Dynamic Routing screen.
Figure 59 Network > Routing > Dynamic Routing
The following table describes the labels in this screen.
Table 42 Network > Routing > Dynamic Routing
LABEL
Dynamic Routing
Cancel
Apply
Chapter 13 Routing
DESCRIPTION
Select to enable or disable this rule.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet mask
of 255.255.255.255 in the subnet mask field to force the network number to be identical to the
host ID.
Enter the IP subnet mask here.
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
segment as your Zyxel Device's interface(s). The gateway helps forward packets to their
destinations.
Click Back to return to the previous screen without saving.
Click Cancel to set every field in this screen to its last-saved value.
Click Apply to save your changes back to the Zyxel Device.
DESCRIPTION
RIP (Routing Information Protocol) allows a router to exchange routing information with other
routers. The RIP version controls the format and the broadcasting method of the RIP packets
that the Zyxel Device sends (it recognizes both formats when receiving). RIP version 1 is
universally supported but RIP version 2 carries more information. RIP version 1 is probably
adequate for most networks, unless you have an unusual network topology.
Select the RIP version from RIPv1 and RIPv2. Otherwise, select Disable to turn if off.
Click Cancel to begin configuring this screen afresh.
Click Apply to save your changes back to the Zyxel Device.
LTE3316 Series User's Guide
108