Troubleshooting and tips
No mouse pointer displayed on the screen
Cause
The mouse is not correctly connected.
Disabled USB ports
Ventilation duct from hard disks / power supply unit
does not engage during installation
The ventilation duct (1) can no longer be correctly installed after the
installation/removal of system expansions.
Cause
Locking slide on the hard drive installation kit
not closed.
38
Remedy
► Shut down your operating system in the
proper manner, for instance using
Alt
+
Del
.
► Switch the device off.
► Check that the mouse cable is properly
connected to the system unit. If you use an
adapter or extension lead with the mouse
cable, check the connections.
► Make sure that only one mouse is
connected.
► Switch the device on.
► In the BIOS Setup, check whether the USB
ports are Enabled (see the "BIOS Setup"
manual or the mainboard manual
Remedy
► Close the locking slide.
+
Ctrl
1
Fujitsu