3Rd Party Racks; Preparation For Rack Mounting - Fujitsu CELSIUS M770 Operating Manual

Rack mounting (optional)

3rd party racks

Installation in most current rack systems from other manufacturers (3rd party racks) is
supported. For more information, contact your responsible sales person.

Preparation for rack mounting

Before mounting in the rack, you must fit one rack panel on the top and one on the bottom of the
CELSIUS. These are unmistakably shaped and can only be fitted to the associated face.
The rack panels and rails are included in the scope of the delivery.
The device must be switched off when installing/removing system expansions
and must not be in energy saving mode.
► Switch the device off.
► Remove all the cables from the device.
► Lay the device as shown below, on a stable, flat and clean surface. If necessary, place a
slip-resistant cloth on this surface to prevent the device from being scratched.
1
► Remove the screws (1).
► Lift the casing cover off the casing (2).
24
1
2
1
Fujitsu