The Operator Panel - KEB Combivert F5 Instruction Manual

Description of the Unit

2.7.3 The operator panel

The function key is used to change between parameter value and parameter number.
FUNC.
SPEED
With UP (▲) and DOWN (▼) the parameter number or, in case of changeable parameters, the value is increased/
decreased. When holding the key it is automatically switched further.
STOP STOP
START START
Principally during a change, parameter values are immediately accepted and stored non-volatile. But at some
parameters it is not sensible that the adjusted value is accepted immediately. When this type of parameter is
changed, a point appears behind the last digit. The value is stored with ENTER.
ENTER
F/R
If a disturbance occurs during operation, the actual display is overwritten with the error message. The alarm mes-
sage in the display is reset by ENTER.
ENTER
=> Error=>
F/R
With ENTER only the error message is reset. The status display continues to display the error that occurred. In
order to reset the error, the cause must be eliminated first. After that the "Reset"-input must be switched or the
inverter must be disconnected from the supply.
GB - 21