Tunnel2
MTunnel0
Table 7 Command output
Field
Link ID
State
Type
Flooding proxy
Related commands
tunnel
•
•
negotiate-vni enable
vxlan
•
encapsulation
Use encapsulation to configure a frame match criterion for an Ethernet service instance.
Use undo encapsulation to remove a frame match criterion from an Ethernet service instance.
Syntax
encapsulation default
encapsulation { tagged | untagged }
encapsulation s-vid vlan-id [ only-tagged ]
undo encapsulation
Default
An Ethernet service instance does not contain frame match criteria.
0x5000002
Up
0x6002710
Up
Description
Tunnel's link ID in the VXLAN.
Tunnel state:
•
Up—The tunnel is operating correctly.
•
Blocked—The tunnel is a backup proxy tunnel. Its tunnel interface is up, but the tunnel
is blocked because the primary proxy tunnel is operating correctly.
•
Defect—The tunnel interface is up, but the VTEP has not received BFD control packets
from the remote end for 5 seconds. You must check for physical link or VXLAN tunnel
problems.
•
Down—The tunnel interface is down.
Tunnel assignment method:
•
Auto—The tunnel was automatically assigned to the VXLAN:
VXLAN IS-IS automatically assigned the tunnel to the VXLAN after VXLAN ID
negotiation.
For a multicast-mode VXLAN, the tunnel (MTunnel) was automatically created and
assigned to the VXLAN to transmit flood traffic.
•
Manual—The tunnel was manually assigned to the VXLAN.
Flood proxy state:
•
Enabled—Flood proxy is enabled. The VTEP sends broadcast, multicast, and
unknown unicast traffic to a flood proxy server through the tunnel. The flood proxy
server replicates and forwards flood traffic to remote VTEPs.
•
Disabled—Flood proxy is disabled.
Manual/Auto Disabled
Auto
Disabled
12