Sony PDW-V1 Operation Manual page 76

To set the internal switch to on
1
2
1
Using a Phillips screwdriver, remove the bottom
cover.
There are five screws fixing the cover.
2
Using a sharp implement such as a ball-point pen, set
switch 4 in the S1902 group to the ON position (on the
front side).
3
Replace the bottom cover.
Note
Tighten the screws firmly.
To enable extended menu display in the
maintenance menu
Carry out the following operations.
76
7-3 Extended Menu
S1902, switch 4
1
AUDIO MONITOR
L
CH-1 CH-2 CH-3 CH-4 CH-5 CH-6
R
ACCESS
SUB
CLIP THUMBNAIL MENU SET
NETWORK
LOCAL
REMOTE
CLIP ESSENCE SYSTEM S.SEL
MENU MARK MENU
PREV PLAY NEXT STOP
IN
TOP F REV F FWD END
8 3,5,7
1
Press the MENU button.
The menu appears in the status display.
2
Hold down the COUNTER button, and press the SET
button.
In the status display, first "MAINTE MENU" appears
momentarily, and then the item group name appears.
3
Using the J/j buttons, display "Setup" in the status
display.
4
Press the k button.
5
Using the J/j buttons, display "> Extended" in the
status display.
6
Press the k button.
The status display shows the current setting (">>
DISABLE").
7
Press the j button, to display ">> ENABLE" in the
status display.
DATA DATA DATA DATA
VITC VIUB COUNTER VITC ALARM
dB OVER dB OVER dB OVER dB OVER
0 0 0 0
-12 -12 -12 -12
-20 -20 -20 -20
HOURS MINUTES SECONDS FRAMES
-30 -30 -30 -30
AUDIO 625 IMX 50 40 30 [ ]
-40 -40 -40 -40
48CH 16 24 BIT 525 DVCAM
-60 -60 -60 -60
CH- 15 CH- 26 CH- 37 CH- 48 BATT E F
2
SHUTTLE JOG
L
CH-7 CH-8
R
RESET SHIFT
MARK1
OUT
MARK2
4,6