Edit Parameters By Option Page - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Edit Parameters by option page

81 | © 2013 ABB | 1SDH001000R0002 - L7804
Continued from the previous page
The tick signs indicate that the changes are not effective. In order make a change effective, the
release must be programmed. To program the release, you need to press the key HOME, that
it opens the page Programming (see page 83). Alternatively, you can go up through the higher
level menus until the page is displayed.
In the page Programming:
• A list of the changes made is displayed.
• You are asked to confirm, cancel, or modify the settings.
NOTE: before confirming a change in the page Programming, other changes can be
made both in the same menu and in higher or lower level menus. In fact, the changes
remain in memory unless they are cancelled in the page Programming, and the
confirmation or the cancellation refers to all the changes made up to that moment
but still not confirmed.
NOTE: In the case of Edit Parameters by option, selecting a value returns you
automatically to the start menu.
The page appears as follows:
A
Figure 80
The following table provides a description of the various areas of the page:
Pos. Description
A Cancels the operation, and opens the start menu.
B Name of the page.
C Name of the parameter to be set.
D List of the selectable values.
E Scroll the list
C
B
Modify Parameter
Frequency
50 Hz
60 Hz
Ekip Touch protection release | 8 - Setting the parameters
ABB | SACE Emax 2
D
E
E