Transport And Checking On Receipt; Introduction; Weight Of The Circuit-Breakers With Packaging; Transport Of The Packaged Circuit-Breaker - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

2 - Transport and checking on receipt

Introduction The Emax 2 circuit-breakers, on account of their weight, require special attention during
Weight of the circuit-breakers
with packaging
Transport of the packaged
circuit-breaker
7 | © 2013 ABB | 1SDH001000R0002 - L7804
transport and handling.
They are distributed with following packages:
• single package for fixed circuit-breaker
• two packages for withdrawable circuit-breakers (one package for the fixed part and one
for the mobile part).
The following notes regard transport, handling and storage.
The following table specifies the weights of the circuit-breakers with packaging:
Fixed
III IV
E2.2 46 58
E4.2 63 77
E6.2 118 134
NOTE:
• weights are indicated with reference to the basic circuit-breakers including
protection release and its sensors, without terminals and without accessories.
• the weights of the fixed part of withdrawable circuit-breakers refer to the version
with horizontal rear terminals.
Consult the table "Weight of the circuit-breakers with packaging" before proceeding with the
transport.
WARNING! Improper lifting can result in death, serious injury to persons and
damage to the equipment. Never lift a circuit-breaker and / or a fixed part
above other people.
IMPORTANT: The trained personnel in charge of handling and lifting must use
appropriate safety equipment.
Moving part of
withdrawable device
Fs III IV
53 60
67 81
151 129 143
Emax E2.2-E4.2-E6.2 circuit-breakers | 2 - Transport and checking on receipt
ABB | SACE Emax 2
Fixed part of
withdrawable device
Fs III IV
41 49
57 69
159 96 109
Fs
123